Easy to solve the device shows "TEST ONLY" for SATXTREM X800 /X800 HD

Post Reply
Admin
Site Admin
Posts: 33
Joined: Sat Jan 06, 2018 6:14 pm

Easy to solve the device shows "TEST ONLY" for SATXTREM X800 /X800 HD

Post by Admin » Fri May 31, 2019 1:34 am

Easy to solve the device shows "TEST ONLY" for SATXTREM X800 /X800 HD

Pls follow these steps as below

1) Prepare a u disk. better no other file in it, format it to FAT32

2) Create a new product_config.ini file in the U disk(Note: the "product_config.ini"file can download in the attachment,after downloaded ,pls remember to release)

3) Turn on the device, then insert the U disk into device, it will get the device ID informations and will create a chip_sn_0000.dat file in the U disk automatically.

4) send this .dat file to sellers, and sellers will send a chip_sn_encrypto_0000.dat file back to you.

5) copy the chip_sn_encrypto_0000.dat file into the U disk. then insert the U disk to device again and turn on device, Wait a while (about 40 seconds), u disk lights do not flash. Restart the set-top box. successful!

Remark:
if the screen shows: can not found product_config.ini file, kindly insert your U disk to device again, your U disk should input the product_config.ini file (How to create product_config.ini, set your PC can watch the file's Suffix name, then create a txt file, then rename it to be "product_config.ini" , then finished.)
Attachments
product_config.rar
product_config.ini
(82 Bytes) Downloaded 269 times
How-to-solve-TEST-ONLY-problem.jpg
How-to-solve-TEST-ONLY-problem.jpg (657.7 KiB) Viewed 1873 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest